We are the leading distributor of automatic drain Valve, Aluminum piping, Clipped piping System, PEX piping system, PPRC pipes, pressure vessels, compressed air leak management system, compressed air energy monitoring system, pure water accessories and plastic pipe fitting.
They are designed for the use of course of action parameters. Piping systems are stated in the piping specifications.
Types of pipes:
Pipe produced by drilling billets followed by rolling or drawing or both.
They are used for high-pressure applications.
at. Electric fusion welding: Single or double longitudinal welded but welded tubes are produced by manual or automatic arc welding in the preformed tube.
b. Welded electrical resistance: Bearing pipe on the line but the weld is being welded Coalescence is produced by heat from a pipe to a pipe.
3. Forged and bored:
Pipes prepared by forging then boring to the desired thickness.
A typical examination requires a week or less of time on the site and includes the following procedures:
1. Analyze the supply equipment
2. Measure storage capacity
3. Qualify the need for air
4. Solve production problems
5. Create system diagrams
6. Determine operating costs
7. Develop an action plan
8. Provide a complete report
The cost of energy is one of the main contributors. consequently, reducing the consumption of electrical energy, thermal or in any other form always helps in business sustenance and growth. additionally, because of fossil fuel energy, any reduction in energy consumption would also average conservation of natural resources and, most importantly, less impact on the ecosystem.
The need for steam verification is gaining importance with rising energy and water costs.
Stream Generation System:
a) Understand the existing system by:
b) Assessment of the performance of steam generators:
c) Overall steam balance for the refinery with detailed steam production and steam consumption per unit for HP, MP, and LP. This also includes condensate recovery.
d) Steam consumption of equipment (actual) was compared to w.r.t. Equipment Steam Requirement (Design)
Steam dispensing System:
a) The length of the main steam dispensing manifold throughout the refinery was approximately 19 km
b) The refinery lines were inspected for the zones As a consequence, appropriate suggestions were made.
Study of steam leaks and steam traps:
a) Location of fog leaks, character and amount of steam
b) Steam losses were quantified by measuring plume length during dry and rainy seasons
c) Total vapor loss of two at the cloud leak in refinery ~ 100 TPD
d) About 7000 steam traps were categorized as OK, defective, defective, out of order and missing.
e) The recommended test intervals for steam traps have been indicated
f) Recommendations to reduce the escape of steam have been provided.